Josh-the-Locksmith
25 Years Experience
Austin, TX
Male, 46
I've been a locksmith since 1998. I did automotive residential & commercial work from 1998 to 2008. From 2008 to 2018, I did some residential, but mostly commercial work. I have been project managing & estimating since 2018. I used to locksmith in the Chicago area, now the Austin area.
1.21 gigawatts.
Share Answer: 
Take a drill bit the same thickness as the screw, or slightly bigger, & drill the stripped screw as if you were trying to drill a hole right down the center of it. You really only need to drill enough to get the head of the screw off.
Share Answer: 
I highly doubt it. I'd just cut it off if I were you. They don't usually have a way to disassemble stuff like that.
Share Answer: 
Most likely your lock was masterkeyed. When you picked it 180 degrees, a master pin probably fell into the keyhole. If you're renting, you will need to have your landlord have his locksmith come out & fix it. If it's your own house, you'll need to take the deadbolt off, take it into a lock shop, & they will remove the stuck pin & probably have to rekey it back to your key.
Share Answer: 
Swim Instructor
What are the physical traits that make for the "ideal swimmer's body"?
Birthday Party Clown
OK seriously, how DOES the clown car thing work?
Fashion Forecaster
What country is the most fashion-forward?
Sounds like you may have had some master pins fall into the key hole. You need to have someone take it apart & repin the lock. Take it to a lock shop, have someone come out, or buy a new deadbolt.
Share Answer: 
There is sometimes a series of letters & numbers stamped into the face of the lock. Like "132E". If you have 1, take that number & the brand of the file cabinet into a locksmith shop, & they should be able to cut you a key. Otherwise of you don't have a code on the lock, you can either remove the cylinder & replace it, or have a locksmith come out & he should be able to do it.
Share Answer: 
Well typically the most standard size hole is 2-1/8". Sometimes people will drill a 1-1/2" hole though, which is probably what you have. Depending on what lock you bought, most can be adapted to fit a 1-1/2" hole. Read your instructions. If you can't figure it out, message me on Twitter at ATXJoshL
Share Answer: 
-OR-
Login with Facebook (max 20 characters - letters, numbers, and underscores only. Note that your username is private, and you have the option to choose an alias when asking questions or hosting a Q&A.)
(A valid e-mail address is required. Your e-mail will not be shared with anyone.)
(min 5 characters)
By checking this box, you acknowledge that you have read and agree to Jobstr.com’s Terms and Privacy Policy.
-OR-
Register with Facebook(Don't worry: you'll be able to choose an alias when asking questions or hosting a Q&A.)
Browse Jobs
Host a Q&A
Search
Submit Your Question
Host a Q&A
Last 7
